Westinghouse iGen4500DF Manuel D'utilisation page 28

TROUBLESHOOTING
PROBLEM
Frost on the propane tank or
regulator
Propane fuel smell
Poor performance or
stalling on Propane
28 | Westinghouse Outdoor Power Equipment, LLC
POSSIBLE CAUSE
If the temperature of the propane tank drops
below the dew point, condensation on the tank
may turn to frost or ice. This typically occurs in
humid conditions.
The Propane tank is not equipped with an
overfilling prevention device (OPD).
Propane fuel tank overfilled.
Fuel regulator or fuel hose and fittings not
securely sealed.
Propane fuel regulator vent active.
Residual fuel from the carburetor dispersing after
operation.
Propane fuel line kinked or crushed.
Fuel selector valve not properly positioned.
engine
Gasoline not purged from the carburetor before
switching to propane.
CORRECTION
Providing all the propane fuel handling equipment is
functioning normally, no correction is needed.
If you suspect your propane fuel tank is not equipped
with an OPD device, discontinue operation immediately
and replace the propane fuel tank with a propane tank
equipped with a an OPD.
If you suspect your propane fuel tank has been overfilled,
discontinue operation immediately and return the propane
fuel tank to the place of purchase or refilling.
Using a soap solution check each connection and tighten
as needed.
The propane fuel regulator is equipped with a vent that
will allow a small amount of propane fuel vapor to escape
from the regulator when the propane tank valve is opened.
This can be normal providing the venting of the propane
is brief. If you suspect that this is abnormal, immediately
discontinue use and have the propane regulator inspected
by a qualified technician.
Normal, no correction is needed.
Inspect propane fuel line and remove kinks or other
obstructions.
Rotate the fuel valve fully until the pointer is directly in line
with the desired fuel.
Close the propane fuel tank valve. Move the fuel selector
switch to gas. Start the engine and allow the engine to run
until the gasoline has been consumed in the carburetor.
Begin propane start up procedure.