DeWalt DCD991 Guide D'utilisation page 15

The belt hook (J) and bit clip (K) can be be attached to either side of
the tool using only the screw (L) provided, to accommodate left- or
right- handed users. If the hook or bit clip is not desired at all, it can
be removed from the tool.
To move belt hook or bit clip, remove the screw (L) that holds it in place
then reassemble on the opposite side. Be sure to securely tighten the
screw.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 10)
NOTE: For best results, make sure
your battery pack is fully charged.
To install the battery pack (H) into
the tool handle, align the battery
pack with the rails inside the tool's
handle and slide it into the handle
until the battery pack is firmly
seated in the tool and ensure that
it does not disengage.
To remove the battery pack from
the tool, press the release button (I)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Squeeze the tool trigger for three seconds to dissipate the slight
electric charge that may still be in the tool. The worklight may come
on for a brief moment.
FIG. 10
I
H
FUEL GAUGE BATTERY PACKS (FIG. 11)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
To actuate the fuel gauge, press and hold the fuel gauge button (M).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
FIG. 11
M
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
13