LF Master Forge BG1795BAL Mode D'emploi page 28

OPERATING INSTRUCTIONS
GRILL BURNER LIGHTING
Warning: Do not lean over grill when lighting. Turn off LP
supply at cylinder when appliance is not in use.
Main Burner Lighting Illustration:
1. Check that the control knobs are in the OFF position.
2. Open valve at tank fully by turning counterclockwise.
3. Open lid during lighting.
4. Push the Electronic Ignition down 3 to 4 seconds while
turning the GRILL control knob to the HIGH position. The
burner should ignite.
If ignition does not take place within 5 seconds, immediately turn the control knob to the OFF
position. Wait 5 minutes and repeat step 4 above or refer to match lighting instructions in
manual.
If by chance the electronic igniter does not light the burner, the burner may be lit with a match
attached to the match extender, located on the inside of the cart door.
Remove the main cooking grate and flame tamers. Keep your face as far away from the grill
surface as possible and pass the match extender to the ports of the main burner tubes. Position
the match near the burner ports and push and turn the control knob counter-clockwise to the
"HIGH" position. After the burner has lit, turn the knob to the "LOW" position and carefully place
the flame tamers and grates back in position. Then turn the control knob to the desired setting.
NOTE: If the grill will not light after several attempts see the Troubleshooting section of
this manual. Turn the control knobs to the OFF position when not in use.
SEARING BURNER & ROTISSERIE BURNER LIGHTING:
1. Check that the control knobs are in the OFF position.
2. Open valve at tank fully by turning counterclockwise.
3. Open lid during lighting.
4. Push the Electronic Ignition down 3 to 4 seconds while
turning the SEARING or ROTISSERIE control knob to
the HIGH position. The burner should ignite.
5. Once it is lit, release electronic igniter and keep pushing
the knob for another 15 seconds to ensure the burner
stays lit.
Main Burner Control Knob
Searing Burner Control Knob
28