Natural Gas Conversion - LF Master Forge BG1795BAL Mode D'emploi

NATURAL GAS CONVERSION

PREPARATION:
Before beginning conversion, make sure all parts are present. If any part is missing or damaged,
do not attempt to convert. Please have your owner's manual and part number available for
reference, and contact customer service 1-800-963-0211 for replacement parts.
Natural gas conversion Kits (Part No. 839966-72) Part list.
1. NG Orifice x 7pc
φ 1.45
4. M19 Wench x 1pc
(NOT INCLUDE)
WARNING: This conversion kit shall be installed by a qualified service agency in
accordance with the manufacturer's instructions and all applicable codes and requirements of
the authority having jurisdiction. If the information in these instructions is not followed exactly,
a fire, explosion or production of carbon monoxide may result causing property damage,
personal injury or loss of life. The qualified service agency is responsible for the proper
installation of this kit. The installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's instructions supplied with
the kit.
WARNING:
Place the grill on a flat, level surface.
Before the conversion, make sure all control knobs are in the OFF position, LP tank valve is
closed, and tank is disconnected from regulator and removed from grill.
1. Turn off gas supply, and then remove cap on gas supply side.
2. Recommended: Install a shut-off valve on gas supply side before installing the socket.
3. Socket should be installed by an authorized technician in accordance with the national fuel
gas code (NFPA 54-2018/ANSI223.1-2018).
4. Before inserting plug, turn on gas supply and leak test all connections including the stem of
the shut-off valve and the opening of the socket. For best results, use an ammonia-free soap
and water solution.
2. NG hose (NOT INCLUDE)
10ft length.
5. Slotted screwdriver x 1pc
3. Orifice removal tool x
1pc
6. NG label x 1pc
13