Pramac Powermate PMi 2000 Mode D'emploi page 19

examine it to find out the breakdown.
The outputting and overloading indicator lights
If the generator is in a good working order, the outputting indicator light (green) is
on. If the generator overloads ( over its rated power), or in case of a short circuit
inside the electrical machine it links to, the outputting indicator light (green) will
turn off, while the overloading indicator light (red) will lighten. At this time, the
current to the linked electrical equipment will be cut off. If the red indicator light is
on, you should turn off the engine, and examine why it is overloaded.
Before you link the wire to the generator, first examine if it is in good working
order, and whether its electric power level exceeds the generator capacity or not.
Then engage the cable of the electrical equipment and start the generator.
Warning:
After the generator starts up, the red light and the green light may shine at the
same time, if the red light goes out, it is normal. If the red light still shines, please
inquire the generator agent.
Use of the continuous current
The continuous current AC socket is only applicable to charge the battery (12V).
Attention
During the operation process of the direct current, turn the intelligent
gasoline-saving valve to the "CLOSE" position.
First connected the charging cable (Fig. A) to the direct current socket of the
generator
Then link it to the junction side of the battery.
Start the engine
-
19