Pramac Powermate PMi 2000 Mode D'emploi page 18

Please comply with the following regulations:
If you need to lengthen the cable, please use the soft cable with rubber
cover (according to IEC245 or relevant requirements).
The length requirement of the lengthened cable: 60 meters for 1.5 square
millimeters one, and 100 meters for 2.5 square millimeters one. If the cable is too
long, the resistance in it will become so large that the applicable electric power
will decrease.
Keep the generator far away from other wires and cables, such as business
electricity supplying circuitry.
Warning:
The alternative AC and the direct electrical DC source can be used at the
same time. If you want to use the alternating current and direct DC current
socket at the same time, make sure that the total electric power will not exceed
the summation of alternating and direct current.
Remember! Most electrical equipment's starting power is higher than the
rating power.
Use of AC alternating current
1 Start the engine, and make sure the indicator light (green) is on.
2 Make sure that the switch of the electrical equipment to be used has been
turned off, before to plug it into the generator.
3. Start the equipement
Look out
When the electrical equipment is connected with generator, make sure the
equipment works well before connecting. If the running of the equipment is
abnormal, the speed decreases, or the machine suddenly stops working, you
should turn off the engine immediately, disconnect it from the circuit, and
-
18