Peg-Perego Ypsi Bassinet Notice D'emploi page 13

MECHANISMS (HANDLE, BACKREST)
WITH THE CHILD IN THE PRODUCT.
• IF A SHEET IS USED, CHECK THAT
DIMENSIONS FIT THE DIMENSIONS OF
THIS BASSINET.
• STRINGS CAN CAUSE STRANGULATION!
DO NOT PLACE ITEMS WITH A STRING
AROUND A CHILD'S NECK, SUCH AS
HOOD STRINGS OR PACIFIER CORDS.
DO NOT SUSPEND STRINGS OVER A
BASSINET OR CRADLE OR ATTACH
STRINGS TO TOYS.
• DO NOT PLACE THIS BASSINET NEAR A
WINDOW OR A PATIO DOOR WHERE A
CHILD COULD REACH THE CORD OF A
BLIND OR CURTAIN AND BE STRANGLED.
• THIS PRODUCT IS DESIGNED TO HOLD
A SLEEPING BABY. WHEN THE CHILD
IS ASLEEP, THE BASSINET BACKREST
SHOULD BE FULLY LOWERED.
NOTICE
THIS ARTICLE MEETS OR EXCEEDS
ALL REQUIREMENTS COVERED IN
ASTM F 2194 STANDARD AND LATEST
REVISIONS.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
Instructions for use
1 Rotate the handle bar of the Ypsi Bassinet
upwards, until you hear "click".
2 Remove the foot muff and the mattress.
3 Rotate the metal rod on the head side upwards
(fig_a) and lift the backrest as shown in the
picture (fig_b).
4 Rotate the metal rod again, downwards, (fig_a)
and use the latch to fasten it to the hooks (fig_b).
5 Insert, into the slot, the end of the belt that
adjusts the position of the backrest.
6 Lift the backrest (fig_a) and, using the latch, place
the metal rod near the hooks (fig_b), then fasten
it (fig_c).
7 Lower the seat and fasten the two zips on the
side of the bassinet.
8 Insert the mattress, making sure the opening of
the case is facing down and not up, in contact
with the child.
9 HOOD: lower the back of the hood (fig_a) and
close the zip (fig_b). It is also possible to draw out a
section of fabric from the hood to protect the child
from sunlight (fig_c) and easily slip it back into the
hood when it is no longer necessary.
10 FOOT MUFF: position the foot muff on the Ypsi
Bassinet and fasten it to the padding with the
zip, as shown in the picture.
11 The Velcro straps can be used to fasten the foot
muff to the hood, guaranteeing the child is
better protected against the elements. Lift the
edge of the foot muff (fig_a), turn it upwards
(fig_b) and fasten it to the hood using the Velcro
straps (fig_c).
12 The foot muff's turn-up is divided into two
13