Carmen CR5190 Mode D'emploi page 6

Warning! Risk of injury through electric shock!
· Protect the appliance from moisture. Never put it into the dishwasher. Never
immerse it in water!
Use in accordance with purpose
›
The appliance is only intended for straightening and styling human hair.
No liability is accepted for any damage resulting from use for other purposes,
faulty operation or amateur repairs. Guarantee services are also excluded in such
cases.
The appliance is not intended for professional purposes!
Operating Instructions
›
FIGURES 1 – 9
Preparing the hair
·
Wash your hair and dry it well.
·
Comb your hair thoroughly. Do not use hairspray or other flammable
chemical hair care products.
·
Place a hand towel around your neck to prevent the possibility of skin burns.
Switching on the appliance
Note!
During operation or during the cooling phase, place the appliance only on the
stand (i).
FIGURES 1 – 3
· Use the locking disc (h) to open the appliance (see fig. 1). Insert the mains plug and
switch on the appliance using the ON/OFF switch (a) (see fig. 2). The temperature
control lights 1-3 illuminate immediately, the 4th flashes until the appliance has
reached its pre-set temperature of 160°C (see fig. 3). The pre-set temperature is
reached after approx. 1 minute.
Setting the temperature
FIGURE 4
· Select the suitable temperature for your hair type. Notes on this are found in the
table below!
Setting lower temperature levels
·
Press the "–" key repeatedly on the switch (b) until the required temperature level is
set (see fig. 4a). Minimum temperature 100°C.
Setting higher temperature levels
· (b) until the required temperature level is
Press the "+" key repeatedly on the switch
set (see fig. 4b). Maximum temperature 200°C.
Note!
· For every newly selected temperature level the respective control light flashes until
the temperature is reached. Higher temperature levels are reached in just a few
seconds, a reduction of temperature level takes effect more slowly.
English • 3