DRESTER Hedson GP 24 Mode D'emploi page 8

11.5 SETTINGS
8
11.5.1 STATISTICS
11.5.2 WATER CHANGE
11.5.3 WORK HOURS/
INTELLIGENT HEATER
11.5.4 WATER TEMPERATURE/
HEATER
11.5.5 TIME
11.5.6 FACTORY RESET
11.5.7 VERSION/MODEL
11.5.8 SELF TEST
11.5.9 ALARM LOG
11.5.10 LANGUAGE SELECTION
GP 24
11.5.1 STATISTICS
STATISTICS Totals
The machine logs total number
of washes, total operated time
and total number of shot
medium collections.
STATISTICS Energy
The machine is equipped with
an advanced current monitoring
system which makes it possible
to determine the consumption
of the pump motor.
This is shown as an average
consumption/wash and is
automatically reset every time
the machine is cleaned. The
value is different depending
on how long the average wash
cycle is.
STATISTICS 7 days
The machine can also identify
the amount of use during the
last seven days, illustrated in
a graph. This can be used for
identifying peaks in work load.
11.5.2 WATER CHANGE
If the CleanRinse is being used
in the machine, the water change
intervals may be increased to
approx. 400 washes.
11.5.3 WORK HOURS/
INTELLIGENT HEATER
The GP 24 is equipped with
an intelligent water heating
system that saves up to 50%
more energy than a traditional
thermostat controlled heater.
Enter the time for when the
machine should be ready for
washing in the morning, the
time for when the machine is
no longer used in the afternoon
and which weekdays the
schedule should be active.
The machine will then
automatically start heating
the water in time so that it is
at desired temperature at the
"STARTTIME". The machine is
default set at 7:00-16:00, MON-
FRI. This means that the water
will be at operation temperature
between these hours.
If intelligent heating for some
reason isn't desired, set the time
schedule from 00:00-00:00,
MON-SUN and the heater will
keep the water warm 24 hours,
7 days a week.
230754-EN rev.2 2017-07-13