User Interface - DRESTER Hedson GP 24 Mode D'emploi

10.5 STD/SUV WHEELS
The machine is default set at wheel dimensions up to 20".
Washing wheels larger than 20", or SUV-wheels, press the
button. An icon showing that SUV-mode is activated will
now show up in the LCD.
In SUV-mode, the dynamic arm will make a larger sweep
to clean the bigger rim area. The SUV-mode will automat-
ically cancel after four wheels have been washed.
If you wish to cancel the SUV-mode, just press the button
again. The STD/SUV icon up in the LCD will now disap-
pear and the machine is optimized for standard wheels.
To keep the SUV mode, press the button during 4 sec.
10.6 SETTINGS
The Settings mode enables you to view and change
advanced system parameters. Thanks to our
sophisticated control system in this wheel washer many
settings can be altered. This is normally not a part of the
everyday use.
To enter settings, press the button on the user panel.
10.7 LID CONTROLS
These buttons opens or closes the lid.

11. USER INTERFACE

11.1 BASIC NAVIGATION
• The display shows four software defined options in
the bottom field.
• To adjust values, use the operation buttons. Usually
the furthest right is ENTER or NEXT and the left is
BACK or CANCEL.
• You can always abort by pressing the STOP-button.
11.2 MAIN SCREEN
Water Door
change open
indicator
Time
Wash programs
230754-EN rev.2 2017-07-13
GP 24
Trolley in
Heater
place
active
SUV wheel
activated
Error
warning
11.3 WASH PROGRAMS
• Start a wash cycle by pressing
one of the operation buttons
• If a trolley is connected to
the machine it will start by
loading a wheel into the
machine.
• The machine will start
and display the chosen
wash cycle together with a
wash icon. When washing
is finished, blowing and
CleanRinse will start.
• If a trolley is connected, the
machine will unload the
washed wheel, move the
trolley and load a new wheel
that should be washed.
• PLEASE NOTE: If 300 washes
are exceeded, a warning
will flash alternately with
the checkmark after finished
washing cycle.
• The machine will also remind
the user of checking water
level since this is important
for the wash performance.
This is done by flashing
an icon of the water level
indicator alternately with the
checkmark.
11.4 EDIT WASH SETTINGS
The wash programs are editable
– times of wash, CleanRinse and
air blow time. Hold the wash
program button pressed down
for 3 seconds for the program
that should be edited. The
screen WASH SETTINGS will
show up. Use the operation
buttons to increase or decrease
the time.
Increasing the CleanRinse-time
should be done with caution. A
longer time will consume more
tap water. The CleanRinse can
be turned off by decreasing the
time until OFF is shown in LCD.
7