Gas Valve Access - Inca Metal Cutting GALAXY Série Manuel D'installation Et Guide De L'utilisateur

1/. Remove the air intake louver at the front of the fireplace
2/. Remove the outer glass as per instructions on page 38
3/. Remove the inner louvers
4/. Remove the fan ducts as shown in diagram above right
5/. Lift the fan out, fans are attached to the metal floor of the fireplace with heavy duty magnets as
shown below.
6/. Once removed from the floor the fan will slide out through the opening.
7/. When replacing fans make sure they line up totally with the fan ducts once the fan ducts are put back
into place. This will ensure the air is properly circulated between the 2 glass panels to maintain the
outer glass temperature as certified.
8/. To replace fan and reassemble the fireplace go in reverse order from steps 7 through 1.
The pictures above show the electrical box that controls the fan, the power cord attached and the strain relief
connected to the box. / Les photos ci-dessus montrent la boîte électrique qui contrôle le ventilateur, le cordon
d'alimentation fourni et le réducteur de tension connecté à la boîte.
3.3.12 GAS VALVE ACCESSIBILITY / ACCESSIBILITÉ ROBINET DE GAZ.
TURN THE MAIN GAS & POWER OFF TO FIREPLACE BEFORE COMMENCING ANY WORK ON
THE FIREPLACE THIS SHOULD BE DONE BY A LICENSED, CERTIFIED GAS INSTALLER
TURN LE PRINCIPAL GAZ ET MISE HORS TENSION AU FOYER AVANT DE COMMENCER
TOUT TRAVAIL SUR LA FOYER CELA DEVRAIT ETRE FAIT PAR UNE LICENCE, VOTRE
1/. Remove the outer louver and the outer front glass.
FOURNISSEUR DE GAZ
Page 41 of 57