Inner & Outer Glass Panel Removal & Installation - Inca Metal Cutting GALAXY Série Manuel D'installation Et Guide De L'utilisateur

Step 6
th
Install the 5 log on the right side of the fireplace from on top of the 3
there is only one row of holes and resting on top of the 2
Once correctly installed your burn media should look like the picture above.
3.3.6
INNER & OUTER GLASS PANEL REMOVAL & INSTALLATION.
BE VERY CAREFUL WHEN HANDLING THE GLASS. DO NOT DAMAGE
OUTER GLASS PANEL REMOVAL
1/. Do not attempt removal until fireplace and glass are cool to touch. Remove front air intake louver
2/. Unscrew the 3 front thumbscrews at the bottom so they are loose and slide back towards yourself
3/. Install glass suction cup lifter, do not attempt removal without suction lifter firmly attached.
4/. With aid of suction lifter, lift glass straight up, then while lowering the glass, carefully angle bottom towards you
and past front of fireplace until cleared at the bottom. Be extra careful so as not to damage glass.
5/. Removal of the front and side panels of glass is the same, but side panels do not have to be removed unless
damaged
INNER GLASS PANEL REMOVAL.
1/. Do not attempt removal until fireplace and glass are cool to touch. Remove inner louvers before attempting to
remove the glass.
2/. Install glass suction cup lifter, do not attempt removal without suction lifter firmly attached.
3/. Remove the top 3 thumbscrews
4/. Hold suction cup lifter and loosen the bottom 3 screws, unlike the top thumbscrews these do not
need to be completely removed but leave the bottom channel in place.
5/. With aid of suction lifter, lift glass straight up, then while lowering the glass, carefully angle bottom towards you
and past front of fireplace until cleared at the bottom. Be extra careful so as not to damage glass.
6/. The inner side glass should not need to be removed unless damaged as it is easily accessible once the front glass is
off
INNER GLASS PANEL INSTALLATION.
Carefully angle the front glass up into the top of the fireplace then lower into bottom glass channel. Lightly tighten the 3
thumb screws at the bottom. Install 3 thumb screws lightly to hold the top of the glass. Make sure the glass is even with
the side glass then hand tighten all 6 thumb screws. Be careful not to damage silicone strip on glass edges.
rd
log, over the burner pan where
nd
log
Page 37 of 57