ESAB WARRIOR 500i CC/CV Manuel D'instructions page 11

Masquer les pouces Voir aussi pour WARRIOR 500i CC/CV:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

US
Connection instruction
The power source is connected to 460V from the factory. If a different mains voltage
is required, the cable on the printed circuit board must be moved and placed on the
correct pin. See picture above. This operation must be carried out by personnel
having appropriate electrical knowledge.
Installation of mains cable
A mains cable needs to be installed. It is then important that the earth connection to
the bottom plate must be made in a correct way. See the picture above for the order
in which the washers, nuts and screws are placed.
- 11 -
bu22a
© ESAB AB 2013

Publicité

Table des Matières
loading

Table des Matières