Dometic Waeco PerfectView CAM24 Notice De Montage Et D'utilisation page 32

Mounting the camera
Tip!
We recommend greasing the threads of the bolts to
prevent corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different
points for the drill holes (Fig. b, page 6).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws
(Fig. c, page 6)
Caution!
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 4 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (Fig. d, page 6)
Caution!
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 4.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M4 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
32
PerfectView CAM24, CAM27