Important; Warranty And Ce Certification - Degometal GO 248 Manuel De L'utilisateur

5. Safety instructions operation

IMPORTANT

Follow the safety instructions to protect against electric shock, injury and fire hazard:
- This tool may only be used to set blind rivets; it may not be used for other purposes, e.g. as a hammer.
- Do not overload the tool, and ensure that it is only used within the prescribed capacity range (see 1.1).
- Do not expose the tool to moisture or rain; do not use the tool near flammable substances or gases.
- If the tool is hung from the hanging hook during use, ensure that the tool cannot fall.
- Remove the battery when the tool is not being used and when submitting it for repair or service.
- Keep the tool in its packaging and out of reach of children when it is not in use.
- Always wear safety glasses while working with the tool. The use of personal protection equipment,
such as clothing, gloves, safety helmet and other necessary protection is strongly recommended.
- Never block the ventilation holes on the tool body and avoid sticking anything in them.
- Ensure that the mandrel collector is in place during use.
- Use only original replacement parts for repairs.
- Repairs must be performed by qualified personnel. In case of doubt, always return the tool to an
approved point of sale;.
- Only use the tool with the pre-drilled and punched holes of the correct diameter, as specified
in our catalogue. The blind rivets may be ejected from the tool. Never point the tool towards
yourself or other persons or animals.

6. Warranty and CE certification

6.1 Warranty
This riveting tool, with the exception of the battery, is covered by a 12-month warranty, starting on
the date of sale, as shown on the invoice. This warranty does not cover wear parts and consumables.
Damage caused by normal wear, overload, or improper use and handling are not covered by the war-
ranty. Defects caused by quality problems are covered by this warranty, and the tool will be repaired
or replaced at no charge. Claims are only accepted if the complete riveting tool is returned to the
approved point of sale.
6.2 CE Certification
EC Declaration of Conformity
We hereby declare that, when used in accordance with the manual, the battery-powered riveting tool
conforms to the following standards or standardized documents:
EN ISO 12100:2010, EN 55014-1, EN 55014-2, in accordance with regulations 2004/108/EC and 2006/42/EC
Carros, January 2018
www.degometal.com
Corinne JOUX, CEO
- 9 -