Table des Matières
Publicité
3. Connect the power cord, monitor, and keyboard.
4. Press the Power button on the front panel to turn on the appliance.
Note: By default, your appliance is configured to obtain an IP address on your
network using DHCP. To specify a static IP, use the console administration
interface; see Barracuda Campus for more information:
https://campus.barracuda.com/doc/78155570/
Note: Models 690 and higher come with two network interfaces. One is
active and the other is inactive, denoted by a plastic RJ45 connector in the
port. The inactive port can be enabled in two ways. One, via NIC bonding
which allows users to bond multiple network interfaces into a single channel;
note that you must have two separate network connections and this is not
to be used for one data pipe. Two, through traffic management. Manage the
traffic that goes out of each NIC, that is, replication traffic through the default
interface, and backup traffic through the secondary interface. To enable the
inactive network interface, contact Barracuda Networks Technical Support:
https://www.barracuda.com/support
4
Open Firewall Ports
Note: For maximum security, place your device behind a corporate firewall.
If your Barracuda Backup appliance is located behind a corporate firewall,
open the following ports on your firewall to ensure proper operation:
PORT
DIRECTION
22
Out
80
Out
123
Out
443
Out
1194
Out
5120
Out
5121-5129*
Out
*Barracuda Backup uses these ports to securely transfer data over the Internet
to the offsite storage location. Contact Barracuda Technical Support
(https://www.barracuda.com/support) to restrict outbound network traffic
on these ports to only reach Barracuda Networks.
3
Setup
TCP
UDP
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
USAGE
Technical Support Services
Communication
Network Time Protocol (NTP)
Communication
Communication
Barracuda Backup
Replicate data to Barracuda Cloud Storage
Publicité
Table des Matières
