NSK Ti-Max X10l Manuel D'utilisation page 12

7-2 Cleaning
Manual Cleaning (External Surface)
1) Remove debris on the handpiece surface using a brush under running water (at 38°C or less).
DO NOT use a wire brush.
2) Wipe off moisture on the surface using an absorbent cloth.
CAUTION
• If water enters the handpiece, using an air syringe, blow air into the rear of the handpiece to remove the internal water.
Automatic Cleaning (External and Internal Surfaces)
Use a thermo-disinfector in accordance with ISO 15883 (EN ISO 15883).
Refer to the thermo-disinfector manual.
CAUTION
• After washing with thermo-disinfector, prior to lubrication, dry the product until all internal moisture is completely removed. Thermo-disinfector
moisture remaining inside the product could reduce the effect of lubrication and could cause corrosion inside of the product.
10