AneX AIR-X Manuel D'entretien page 10

PRE-USE
PROCEDURES
STROLLER ASSEMBLY / DISASSEMBLY
Take the frame out of the box and arrange it on the
floor horizontally (fig. 1). Disconnect the fastener
that fixes the sewing kit (fig. 2). Press the lock
button which prevents accidental frame folding/
unfolding in the direction shown on (fig. 2). Frame
can also be unfolded without pushing and rotation
of button, but for your comfort we propose to use
it. While holding the handle, quickly pull it upward
until the system is latched (you should hear a
distinctive sound) (fig. 3, 4).
In order to fold the frame, press the button on the
stroller handle. While pressing it, turn the folding
mechanism in the direction shown in fig. 5 and
push the handle towards from yourself (fig. 5).
Lower the handle forward and push down on the
frame for it to assume it's initial position when you
unpacked the stroller (fig. 1). There is two ways
of fastening sewing kit - "usual" (fig. 2a) for using
everyday, "fly mode" (fig. 2b) to take on plane as
cabin baggage.
ASSEMBLY AND DISASSEMBLY
OF THE REAR WHEELS
In order to install the wheel, you need to place the
axle in the corresponding place of the frame. Hold the
button and slightly push it until the wheel snaps into
place (you should hear a distinctive sound) (fig. 6).
In order to remove the wheel, push the button and push
the wheel along the axle until it is fully removed (fig. 6).