Maintenance And Care - AL-KO EASY CRUSH LH2800 Notice D'emploi

en
See "Releasing a cutting drum blockage".
Switching off the motor
1. Press the Off-switch (6/5) to switch the motor
off.
CAUTION!
Damage to the machine due to improper
operation!
Incorrect handling can result in machine
damage!
Only feed materials to be shredded af-
ter the machine was switched on. Do not
feed materials to be shredded after the
machine was switched off.
Emptying the grass catcher
1. Switch the shredder off.
2. Pull the lock (9/1) down and the grass catcher
(9/2) out of the base.
3. Place the empty grass catcher (10/2) onto the
guide rail (10/1) and push it completely into
the base.
4. Push lock (10/3) up until it engages.
Releasing a cutting drum blockage
1. Switch the shredder off.
2. Turn the direction of rotation switch (6/3) to
the right (6/2) and press the On-switch (6/6)
(reverse).
3. Now, the materials to be shredded should be
released upwards.
4. Switch the machine off and wait for the cutting
drum to stop moving.
5. Afterwards, turn the direction of rotation
switch (6/3) to the left (6/1) again.
6. Next, switch the shredder on again.
If the material to be shredded is not released up-
wards:
1. Loosen the adjusting screw of the counter-
plate (8/1), until the cutting drum runs freely
again and the blockage is removed.
2. Readjust the counterplate, see description
"Readjusting the counter plate".
If the blockage cannot be removed, please con-
tact our responsible customer service.
18
WARNING!
Risk of injury due to lack of focus while
working!
Ejected parts can cause most severe in-
juries!
When running the machine in reverse,
wear personal protective equipment and
pay attention to ejected material.
Transporting the shredder
1. Switch the motor off and wait for the cutting
drum to stop moving.
2. Next, disconnect the machine from the mains
connection.
3. Secure shredder using the handle (1/1) and
tilt the machine slightly.
4. Pull the machine behind you when moving to
the next location. Pay attention to the ground
to prevent the machine from tipping over du-
ring the transport.

MAINTENANCE AND CARE

The shredder complies with all relevant safety
standards. Repairs are only allowed to be perfor-
med by qualified specialists, and with the exclu-
sive use of genuine spare parts.
After each use, check the shredder for wear
and renew any damaged components.
Keep venting slots (1/12) free from residues
or accumulations.
Do not get the machine wet or expose it to
moisture.
Only use spare parts specified by the manu-
facturer.
Worn or damaged cutting drums or counter-
plates may only be replaced by an authorised
specialist.
DANGER!
Fatal electric shock hazard!
Touching live parts represents an imme-
diate danger of fatal injury from electric
shock!
Disconnect the machine from the mains
connection prior to all maintenance and
care measures and wear protective gl-
oves.
Operation
Easy Crush LH 2800