AL-KO EASY CRUSH LH2800 Notice D'emploi page 18

en
Personal protective equipment:
Wear clothing and protective equipment in
accordance with the regulations in order to
avoid injuries to the eyes, as well as to avoid
hearing impairment.
The clothing must be appropriate (tightly fit-
ting) and must not restrict movements. If you
have long hair, it is essential to wear a hair
net.
The personal protective equipment compri-
ses:
Ear protection
Protective glasses
Work gloves
Safety shoes
Working area:
No further persons, children or animals may
be in the working area of the shredder.
Keep the working area free from material to
be shredded and other objects – danger of
stumbling.
The user of the machine is responsible for ac-
cidents involving other persons or their pro-
perty.
Ensure good lighting of the working area.
Operating times:
When operating in residential areas, observe
country-specific and communally permitted
operating times according to the regulations
on noise pollution.
Work with the machine at daylight or with
good lighting only.
Operation:
Do not reach into hopper or feed chute during
operation!
The cutting drum after-runs after the machine
is switched off!
Only start up the machine, after assembly is
fully completed.
Always perform a visible inspection prior to
using the machine. The machine must be in
a safe operating condition.
Never work alone.
Immediately renew damaged or worn parts.
Only use the machine if it is in the technical
condition stipulated by the manufacturer.
Do not undertake shredding work in the rain,
snow or stormy weather. Do not use the
shredder in wet or damp surroundings.
16
Do not deactivate safety and/or protective de-
vices of the machine.
Always ensure secure standing of the ma-
chine.
Never transport the shredder with the motor
running.
Switch the motor off and wait for the cutting
drum to stop moving prior to moving the ma-
chine.
When moving the shredder, exclusively carry
the shredder on its handle (1/1).
Immediately disconnect the plug from the
mains if the extension cable has been dama-
ged or cut!
We recommend the connection via a earth le-
akage circuit breaker (ELCB) with a rated le-
akage current < 30 mA.
The mains voltage at your location must meet
the information regarding mains voltage in
the Technical Data. Do not use any other sup-
ply voltage.
Use only extension cables approved for out-
door use. with a minimum cross-section of
1.5 mm².
Damaged or fragile extension cables may not
be used.
Check the condition of you extension cable
prior for every use.
Only use the mains connection for the desi-
gnated purpose. Do not pull the mains cable
in order to pull the mains plug out of the so-
cket. Protect the cable against heat and sharp
edges.
Always disconnect the shredder from the
mains connection when not in use.
Route the extension cable such that they do
not interfere and cannot be damage during
shredding.
Immediately switch off the shredder saw and
disconnect it from the mains connection if you
notice any changes.
Always ensure secure
working. Do not bent forward to far.
Do not feed the shredder from an elevated
position.
Safety instructions
standing while
Easy Crush LH 2800