Publicité
Les langues disponibles
Les langues disponibles
User Manual
Receiver Front and Rear
1. Power LED: Indicates Power.
2. Service: Reserved for future use.
3. 24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the
transmitter or receiver. This is only required at one side of the installation.
4. HDBaseT In: HDBaseT Input Port. Connect a compatible HDBaseT transmitter using a single
Cat.6 or above cable for all data signals. Please do not connect to a network port.
5. HDMI Out: Connect to an HDMI display.
6. Audio Out: Connect to a compatible speaker setup or amplifier.
7. IR In: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being
used is within the direct line-of-sight of the IR Extender.
8. IR Out: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR
Transmitter in direct line-of-sight of the equipment to be controlled.
9. RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3-way connection
for the pass-through transmission of RS-232 commands.
10. Link Indicator LED:
a. Illuminated Green: Link is Okay
b. Not Illuminated: No Link
11. Data Signal Indicator LED:
a. Illuminated Orange: Signal is Okay
b. Not Illuminated: No HDMI Signal
Important! Before starting the installation, please ensure that all devices are powered off.
1. Connect an HDMI source device to the Transmitter unit using HDMI cable.
2. Connect one end of the Cat.6/7 cable to the HDBaseT Out port on the Transmitter and the other end
to the HDBaseT In port of the Receiver. U/UTP or F/UTP solid core installation cables are
recommended. For cable lengths please see the Specifications of this manual.
3. Use another HDMI cable to connect an HDMI display device to the HDMI output port on the Receiver
unit.
4. If analogue audio extraction is required, connect one end of the 3.5mm audio cable to the Audio Out
port of the Receiver and the opposite end to an amplifier or speaker setup.
5. Plug the DC power supply into the Transmitter or Receiver and switch on.
6. Power on the source device and display to complete the installation.
In addition to the installation steps outlined above this HDMI 18G Extender can also provide the following
additional/optional functionality:
English
Publicité
