Printer Setting - Oki LE840 Guide De L'utilisateur

2. PRINTER SETUP

2.6 Printer Setting

Power ON
Power OFF
Hold down [MODE]
Turn on the power while holding
down [FEED] & [PAUSE] or
[MODE].
Depending on the settings of your host computer or the interface being
used it may be necessary to change the printer parameter settings.
Follow the procedures described below to change the printer parameter
settings to correspond to your environment.
Incorrect settings can cause the printer not to function correctly. If you
have any problems with the parameter settings, please contact your nearest
Oki Data service representative.
For the settings this manual does not cover, please contact your nearest Oki
Data service representative, or refer to the LE840/LE850 Key Operation
Manual.
ONLINE Mode
[PAUSE]
PAUSE state
Hold down [RESTART]
User System Mode
Select [RESET] menu
Reboot the printer
System Mode
Select [RESET] menu
Reboot the printer
E2-14
NOTE:

Reset

Parameter setting (Section 2.6.2)

Fine adjustment (Section 2.9)

LAN/WLAN (Section 2.6.3)

BASIC (Section 2.6.4)

Z-MODE (Section 2.6.5)

Auto calibration (Section 2.6.6)

Dump mode (Section 2.6.7)

Log (Section 2.6.8)

Self diagnosis

Parameter setting

Fine adjustment

Test print

Sensor adjustment

RAM clear

Interface setting (Section 2.6.10)

BASIC mode

RFID setting

Real Time Clock (Section 2.6.11)

Z-MODE

USB memory (Section 2.6.12)

Reset
2.6 Printer Setting