C-3.Setting Up The Printer - Oki PT390 Manuel D'utilisation

C-3.Setting Up the Printer

This section explains how to set up the printer without using a PC.
With the printer connected to a Windows PC, you can easily change the settings
by using the setup tool contained on the CD-ROM provided with the printer.
For the procedure of installation of the utility, see the "Chapter 3. Installation" in
the "Installation Guide" (\Manuals\PT390_InstallGuide1_en.pdf).
Example (1): Changing the print density to a higher value
The procedure for this setting is as follows.
1. Before starting work for this setting, verify the following conditions of the
printer:
(1) The power is off.
(2) Roll paper is inserted in it.
(3) The cover is closed.
2. Enter special mode.
Turn on the power switch on the right side of the printer while
holding down the FEED switch on the left part of the Top cover.
Change from 100% to 130%
63