User System Mode - Oki LE840 Guide De L'utilisateur

2. PRINTER SETUP
2.6 Printer Setting
(Cont.)
FEED
MODE
LEFT
CANCEL
DOWN

2.6.1 User System Mode

 Key functions in system mode
Key
[MODE]
[CANCEL] or
[FEED]+[RESTART]
[ENTER] or [PAUSE]
PAUSE
[UP] or [RESTART]
RESTART
[DOWN] or [FEED]
UP
RIGHT
[LEFT]
[RIGHT]
ENTER
1. The cursor will not scroll from the bottom to the top or top to bottom
of a menu.
2. The value will not increase or decrease any further than the maximum
or minimum values of a parameter.
3. The cursor will not move any further than the left- or right-most
positions of a field.
4. Any values changed will not become effective if the printer is turned
off without pressing the [ENTER] key.
How to enter the User System Mode
ONLINE
The User System Mode consists of the following menus.
<1>RESET
Used to reboot the printer.
<2>PARAMETER SET ( Section 2.6.2)
Used to set the printer parameters.
<3>ADJUST SET ( Section 2.9)
Used to fine adjust the print start position, cut position, etc.
<4>LAN/WLAN ( Section 2.6.3)
Used to enable or disable the LAN communication and SNMP.
<5>BASIC ( Section 2.6.4)
Used to set the function of basic program when it is loaded to the
printer.
<6>Z-MODE ( Section 2.6.5)
Same as BASIC
<7>AUTO CALIB ( Section 2.6.6)
Used to enable or disable the automatic calibration function.
<8>DUMP MODE ( Section 2.6.6)
Used to print the data in the receive buffer for debugging purposes.
<9>LOG ( Section 2.6.7)
Used to save print logs in USB memory.
How to exit the User System Mode
Select <1> RESET menu to reboot the printer.
Function
Returns to the system mode menu.
Returns to the previous menu.
Displays the next screen.
Saves the settings and returns to the previous
menu.
Moves the cursor up.
Increases a value.
Moves the cursor down.
Decreases a value.
Moves the cursor to the left.
Moves the cursor to the right.
NOTES:
[PAUSE] Hold down [RESTART]
Hold down [MODE]
E2-15
2.6 Printer Setting
(Note 1)
(Note 2)
(Note 1)
(Note 3)
(Note 3)
(Note 3)
User System Mode