MRA GSX650F 08 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
1 Edge protection profile,
2 Clamp sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the covering caps and screws and take off the mirror.
3. Press the safeguard clip on the plug and pull off the plug (Photo 2).
4. Turn out the two screws of the windscreen fastening system (Photo 3) from the inside
front left and right and press out the rubber nuts.
5. Turn out the two screws of the windscreen up beside the mirror and pull out the
rubber nuts (moisten if necessary).
6. Pull the lining slightly upwards from both ends and remove the screen of the lining
through the back.
7. Carefully remove the black plastic cover of the original screen.
8. Insert the accessory screen in reverse order.
9. Pull the edge protection profile on the back, open area of the screen, beginning from
the lining transition to the opposite side. Cut off the rest if necessary.
10.Push the clamping sleeves through the ends of the edge protection profile and press
them slightly together with combination pliers in such a way that the edge protection
profile is clamped.
11.Remove the unit, disconnect the plug and put it to the side.
12.Remove the screws of the inner covering and the front screws of the fairing-screen.
13.Loosen the inner fairing and remove the screen.
14.Assembly in reverse order.
15.Apply the edge guard profile to the exposed rear area of the windshield, starting at
the fairing transition and ending at the opposite side. Cut off the rest if required.
16.It is also possible to push the clamping sleeves over the ends of the protective edge
strip and lightly compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
GSX650F 08/1250 10
Article No..
---
Allen key 4mm
Ring Spanner 10mm
---
Combination pliers
---
3
Required tools