Changing The Tool - Bosch UniversalMulti 12 Notice Originale

OBJ_BUCH-2957-001.book Page 20 Friday, March 3, 2017 2:20 PM
20 | English
Note: If the machine should automatically switch off because
of a discharged or overheated battery, make sure to set the
machine's On/Off switch 2 to off. Charge the battery and
allow it to cool down before restarting the machine. Other-
wise the battery can become damaged.
Removing the battery
To remove the battery 3, press the unlocking buttons 4 and
pull the battery out of the machine to the rear. Do not exert
any force.
Battery Charge-control Indication
When the power tool is switched on, the battery charge-
control indicator 6 signals the still available battery capacity
or an overload.
Indication
Continuous lighting, green
Continuous lighting, yellow
Continuous lighting, red
When the battery charge-control indicator 6 flashes red, the
machine is subject to overload. Please observe the infor-
mation in section "Temperature-dependent Overload Protec-
tion", page 25.
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for
sanding, series
Delta 93 mm
Profile sander
BIM plunge cut
saw blade, wood
and metal
1 609 92A 3AY | (3.3.17)

Changing the Tool

 Before any work on the machine itself (e. g. mainte-
nance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch.
 Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
Please observe the application tools/accessories intended
for your tool.
Accessory
Capacity
>70 %
30–70 %
<30 %
Material Application
Wooden materials, Separating and plunge cuts; also for sawing close to edges,
Plastic, in corners and hard to reach areas;
Non-ferrous metals example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Wood, Convenient, efficient sanding of profiles up to a diameter of
Pipes/Profile, 55 mm;
Paint, Red sanding sheets for sanding wood, pipes/profiles, var-
Varnishes, nishes, fillers and metal
Filler,
Metal
Softwood,
Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush cutting a
Plasterboard, copper pipe, plunge cuts in plasterboard
Thin-walled aluminium
Filigree adjustment work in wood;
and non-ferrous metal
example: sawing openings for locks and fittings
profiles,
Thin sheet metals,
Non-hardened nails and
screws
UniversalMulti 12
Bosch Power Tools