Mitsubishi Electric PEH-P8MYA Manuel D'installation page 17

Other function selections
Now that you know how to change the power voltage setting, there are several other settings that can be changed as well. The following Table lists the various settings that can
be changed through the remote controller and the default settings of the various units.
Table 1
Function
Power failure automatic re- Not available
covery Available
Indoor temperature detecting Indoor unit operating average
Set by indoor unit's remote controller
Remote controller's internal sensor
LOSSNAY connectivity Not supported
Supported (indoor unit is not equipped with outdoor-air intake)
Not supported (indoor unit is equipped with outdoor-air intake)
Power voltage 240 V
220 V, 230 V
Filter sign 100 Hr
2500 Hr
No filter sign indicator
Fan speed Quiet
Standard
High ceiling
No. of air outlets 4 directions
Installed options (high-per- Not supported
formance filter) Supported
Up/down vane setting No vanes
Equipped with vanes
Things to remember when entering function selections:
The basic procedure for entering function selections is the same as described for switching between power voltages. However, there are some differences at step 3 for
selecting the unit number, step 5 for selecting the mode number and step 6 for selecting the unit number. The following Tables 2 and 3 list the various function settings, mode
numbers and setting numbers. Table 2 details the functions of the entire refrigerant system while Table 3 shows the functions that can be set for the indoor unit.
Table 2. Itemized functions of the entire refrigerant system (select unit number 00)
Mode
Power failure auto- Not available
matic recovery Available
Indoor temperature Indoor unit operating average
detecting Set by indoor unit's remote controller
Remote controller's internal sensor
LOSSNAY connec- Not Supported
tivity Supported (indoor unit is not equipped with outdoor-air intake)
Supported (indoor unit is equipped with outdoor-air intake)
Power voltage 240 V
220 V, 230 V
Table 3. Itemized functions of the indoor unit (select unit numbers 01 to 03 or AL)
Mode
Filter sign 100 Hr
2500 Hr
No filter sign indicator
Fan speed Quiet
Standard
High ceiling
No. of air outlets Standard
High ceiling
Installed options (high- Not supported
performance filter) Supported
Up/down vane setting No vanes
Equipped with vanes
3 Setting the unit numbers
Set "00" as the unit number when setting functions from Table 2.
When setting functions from Table 3:
- When setting functions for an indoor unit in an independent system, set the unit number to 01.
- When setting functions for a simultaneous-Twin Triple indoor unit system, assign unit numbers from 01 to 03 to each indoor unit.
- When setting the same functions for an entire simultaneous Twin Triple-indoor unit system, assign "AL" as the unit number.
5 Selecting the mode number
Select from Table 2 and Table 3.
6 Selecting the setting number
Select from Table 2 and Table 3.
Settings
Settings
Settings
PEH-P-MYA
–
–
Mode no. Setting no. Check
1
01
2
1
02 2
3
1
03 2
3
1
04
2
Mode no. Setting no. Check
1
07 2
3
1
08 2
3
1
09
2
1
10
2
1
11
2
Remarks
Approx. 4-minute wait-period after
power is restored.
Remarks
17