Storch ProCut mineral Mode D'emploi page 40

Mitre cut
Use the supplied sliding bevel to ascertain the mitre angle of the object (Fig. g), position the board on the right-hand bear-
ing rail (3) and transfer the angle to the insulating board (Fig. h). Align the rear marking (x) precisely with the height of the
rear cutting guide (13) and loosen the screw (17) for the cutting guide. Position the cutting guide (13) over the insulating
board and fold in the cutting guide (13) until the blade of the cutting component comes into contact with the rear marking
(x) and front marking (y). Retighten the screw (17).
Execute the cut as described above under "Longitudinal and lateral cut".
Fig. g: Mitre cut
Window cut-out (L- cut)
Measure the distances (a and b, Fig. i) between the glued insulating boards and the window frame or jamb and transfer
these measurements to the insulating board being cut. Position this board on the right-hand bearing rail (3) and align the
marking for the cut (a) precisely with the rear cutting guide (13).
Execute the cut as described above under "Longitudinal and lateral cut", but only as far as the marking (b).
Turn the board 90° to the left and align the marking for the cut (b) precisely with the rear cutting guide. Turn the board of
the right-hand window side 90° to the right.
Fig. i
Fig. k
Window
House wall
Insulating board
glued insulating
Fig h: Transferring the mitre angle to the insulating
board
Window
boards
40