Publicité
SUEVIA
with connection parts (
).
For subsequent installation into SUEVIA quick drainage troughs. At risk of frost the installed and adjusted frost
protection guard opens automatically, the adjusted water quantity flows into the troughover the float valve,
situated under the frost protection guard: water in the trough remains in motion and is prevented from freezing!
Surplus water produced by the frost protection guard is channeled through the hole in the lever of drainage
plug. No ice in front of the trough!
(see separate mounting instructions)
Heating element 24 V, 180 W (
) for installation
the trough.
Heating element 24 V (
) for installation
r the trough.
For power supply a SUEVIA Transformer 230/24 V is necessary.
For automatic switch on/off of transformer a thermostat (
) can be additionally installed. To
ensure a frost-free feed pipe, a frost protection heating cable 24 V, 20 W, 2 m (
), or a 24 V,
30 W, 3 m (
) has to be used. The heating cable should be wrapped around the pipe and
connected to the heating element of the drinker in parallel to the power supply cable, coming from the
transformer. If this heating cable is installed on plastic pipes, make sure that this water pipe is suited for warm
and cold water. For better heat distribution the water pipe has to be wrapped first with an aluminium adhesive
tape (
). In close vicinity of animals the frost protection heating cable and the supply line should
be protected against being bitten by the animals or other damages.
Publicité
