Alecto WS-5300 Guide De L'utilisateur page 48

Weather station:
Slide the battery cover at the rear downward, replace the CR-2032 battery according to the markings inside
the battery compartment and slide the battery cover back onto the weather station. Connect the supplied
mains adaptor. The weather station will now start searching for the outdoor sensor for 1 minute. Therefore,
insert batteries into the outdoor sensor within that 1 minute.
Outdoor sensor:
Open the battery compartment by sliding the battery cover downward with a
small screwdriver. Insert 3 x size AA 1.5V batteries according to the figure below,
paying attention to the polarity (+ and -). Replace the cover (batteries are not
included).
2.2 Pairing the weather station / outdoor sensor:
Automatically:
As soon as the mains adaptor is connected to the weather station, the weather station starts searching for
a signal from the outdoor sensor for 1 minute. Therefore, if you insert the batteries into the outdoor sensor
within that minute and the units will 'find' each other, they will be automatically paired and the display of the
weather station will show the temperature transmitted by the outdoor sensor.
Manually:
If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor sensor
(again) with the weather station unit as follows:
1. press and hold the SCAN button on the weather station for 2 seconds until the
flashing in the display
2. Press briefly press the RESET button on the outdoor sensor
3. the units will have found each other (again) after several seconds
2.3 Positioning:
Weather station:
You may choose to suspend the weather station from a wall using a simple screw or to use it
as a desk model using the supplied table stand. In any case, never place the weather station in
direct sunlight or nest to a heat-radiating lamp or stove.
Outdoor sensor:
You may choose to place the outdoor sensor on a flat surface (e.g. a fence or railing) or onto
a pole (max. Ø 32.5mm (excluded)). In any case, make sure to position the unit at least 1.5
meters above the ground, standing freely in the rain and wind.
Outdoor sensor placement tips:
To have the rain and wind meter function as accurate as possible, the
outdoor sensor must be positioned exactly horizontal. To do so, use the
built-in spirit level on top of the outdoor sensor.
To be able to indicate from which direction the wind is
blowing, the outdoor sensor must face the North. See above
the designation N on the outside sensor. Use an accurate
compass (not included) to properly aim the unit.
Ensure that the distance between the outdoor sensor and
weather station is no more than 30 to 50 meters.
48
-
+
-
antenna symbol starts
reset
N
>1,5m