Pur Line MOBY 100 Mode D'emploi page 18

Turn off the air conditioner and avoid
moving it when full.
Position a container (a water tray for
example) underneath the drain hole.
Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
.
When the container is almost full, replace
the rubber plug in the drain hole and
empty the water tray.
Repeat until the unit is emptied.
.
. Replace the rubber plug and tighten the
drain knob firmly.
. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
If you wish to operate the unit without the need to empty the water
tank, please:
Remove the drain knob and rubber
plug and retain for future use.
Connect the drain tube supplied to
the water outlet as shown and locate
the other end into a drain.
FIG.14
FIG.15
13
•
The drain tube may be
extended by adding an
extension tube and using a
suitable connector.
Please note
The drain must be at or
4.
below the outlet level.
Flashing comp / 'full water'
5.
indicator will not function in
this mode of drainage.
6. If you want to extend the
water tube, you can connect
it with another tube (OD:
18mm)
FIG.16
FIG.17
14