Rear Panel - BST ACTIV-218 Manuel D'utilisation

ACTIV-218
15. XFADER ASSIGN SWITCH
Use to assign any channel in each side of xfader
16. XFADER
This crossfader is fully assignable to any of the four main music channels set by the ASSIGN switches.
17. HEADPHONE CUE SELECTOR
Used to choose the signal you want to monitor on the headphone ( either master signal ( post-fade), either cue signal ( pre-fade ).
Note : the CUE signal depends of the position of each CUE button on each channel.
18. SD / USB / BLUETOOTH PLAYER
See explaination later
19. STEREO / MONO SELECTOR
20. MASTER EQUALIZER SELECTOR
Use to disable or enable the 2x5 bands master equalizer.
21. MASTER LEVEL CONTROL
This slider controls the overall output level leaving the Master balanced XLR and unbalanced RCA outputs.
22. ZONE LEVEL CONTROL
This slider controls the overall output level leaving the zone unbalanced RCA outputs.
23. HEADPHONE LEVEL CONTROL
This control varies the volume in your headphones, the volume of the signal heard through the headphones.
24. HEADPHONE SOCKET
This is a 1/4" stereo jack socket mounted on the front face of the mixer for you to attach your headphones.
25. MASTER EQUALIZER
Use to adjust tonality of master signal
26. VUMETER
These LEDs shows the level of what ever is present on MASTER
27. POWER SWITCH
This switches the AC power to the mixer ON or OFF.
Note: Be sure to switch on the power to your mixer before switching on the amplification system.
28. DJ LAMP SOCKET
Use to connect a BNC DJ lamp.

REAR PANEL

29. GROUND
The GND is a terminal for grounding turntables to eliminate hum.
30. CHANNEL 1 PHONO/LINE SELECTOR
Use the selector switch to switch from phono to line level.
31. CHANNEL 1, 2, 3, 4 AND 5 INPUTS
Connect on these inputs either a PHONO device as turntable or either a line level device such as cd player or minidisc,
32. EXTERNAL EFFECT INPUT / OUTPUT
Connect the SEND output jacks to the input of an effect or an echo chamber.
Connect the returninput to the output of an effect or an echo chamber
33. REC OUTPUT
That stereo output is used to connect tape recorder, computer, other units of recording
34. ZONE OUTPUT
Unbalanced zone stereo program output provided by RCA sockets. Connect it to your secondary power amplifier
© Copyright LOTRONIC 2013
BSTDJ.COM
Page 9