Parts Supplied; Optional Equipment - Whirlpool WGT4027EW Instructions Pour L'installation

Masquer les pouces Voir aussi pour WGT4027EW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Parts supplied:

NOTE: Remove parts package from the washer basket.
Check that all parts were included.
Front leveling feet with
nuts (2) (27" models)
Rear leveling legs (2)
(24" models)
Plastic strap (24" models)
Silver double-wire hose clamp
Parts needed:
(Not supplied with washer/dryer)
Inlet hoses with
flat washers
Check local codes, electrical supply and venting, and read
"Electrical Requirements" and "Venting Requirements" before
purchasing parts. Mobile home installations require metal
exhaust system hardware available for purchase from the
dealer from whom you purchased your washer/dryer. For
further information, please reference the "Assistance or
Service" section of the Washer/Dryer Use and Care Guide.

Optional equipment:

(Not supplied with washer/dryer)
Refer to your Use and Care Guide for information about
accessories available for your washer/dryer.
6
Front leveling legs (2)
(24" models)
Shipping strap (27" models)
(Not in parts bag. See
"Remove Shipping Strap.")
Drain hose
Vent clamps
n
Vent elbows and ductwork
n
Mobile Home Installation Kit
n
(Part Number 346764)
Metal exhaust system hardware
n
Alternate parts:
(Not supplied with washer/dryer)
Your installation may require additional parts. To order, please
refer to toll-free numbers on back page of your Use and Care
Guide.
If you have:
Overhead sewer
Floor drain
1" (25 mm) standpipe
Laundry tub or
standpipe taller than
96" (2.4 m)
Drain hose too short
Lint clogged drain
Water faucets
beyond reach
of fill hoses
You will need:
Standard 20 gal. (76 L) 39" (991 mm)
tall Drain Tub or Utility Sink, Sump
Pump and Connectors (available from
local plumbing suppliers)
Siphon Break Part Number 285320,
Additional Drain Hose Part Number
285702, and Connector Kit Part
Number 285442
2" (51 mm) diameter to 1" (25 mm)
diameter Standpipe Adapter
Part Number 3363920,
Connector Kit Part Number 285835
Sump pump system (if not already
available)
Extension Drain Hose
Part Number 285863,
Connector Kit Part Number 285835
Drain Protector Part Number 367031,
Connector Kit Part Number 285835
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008

Publicité

Table des Matières
loading

Table des Matières