Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. Switch the device off by moving the On/Off switch (7) to Position 0 (Off).
9. Remove the plug from the socket.
10. Allow the device to cool down and then clean it again.
Assembly
1. Place the bowl (9) onto the base (6) and carefully press it down.
3. Place the locking ring (1) onto the protective edge (2) and press it on fi rmly on the
lower border of the protective edge (2). You must hear and feel it engage.
4. Place the protective edge (2) with the locking ring (1) onto the bowl (9). Press the
locking ring (1) down fi rmly on the upper edge of the bowl (9). You must hear and
feel it engage.
Perform the steps in reverse to dismantle the device.

Use

ATTENTION!
Before putting the device into operation, check whether the device is clean and dry
and has been correctly assembled.
Never reach into the bowl when the device is switched on and keep hair and clothing
away from it!
ATTENTION: Danger of burns! The device will become hot during use. Make
absolutely sure that you do not come into contact with any heated parts during and
after use of the device.
ATTENTION: Danger of fi re! Sugar residues on the two heat pipes may cause the
device to overheat. Keep the heat pipes clean. Allow the device to cool down and
remove sugar residues with a wooden or plastic utensil.
Do not use the device for longer than 30 minutes without stopping. The device could
overheat and be damaged. Switch it off and allow it to cool down completely.
17
2. Rotate the bowl (9) anticlockwise. Make sure that the
locking lugs on the bowl (9) fi t securely in the metal locks
on the base (6). You must feel them engage.
5. Place the sugar container (3) onto the base (9). Make sure
that the slip-on sleeve on the bottom of the sugar container
(3) sits securely on the axis of the base (6).
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sbl-2807

Table des Matières