Waldmann Lavigo Mode D'emploi page 41

Operation
Calibration of the light control
You can adjust and save the luminaire
brightness with which the work area is
homogeneously illuminated.
Preconditions:
The light control is active.
ƒ
The light intensity in the room due to
ƒ
daylight or other light sources is as
low as possible.
The direct light or direct and indirect
ƒ
light are on.
NOTE: If the light control is calibrated
while the room is illuminated by daylight or
other light sources, LUM CONNECT MAN-
AGE regulates the light intensity on a high
level. This may result in the light not being
switched off automatically even if the light
intensity in the room is sufficient.
X Dim the luminaire until the work area is
illuminated with the required brightness.
This will save the set brightness. If the
brightness in the detection range of the
daylight sensor changes, LUM CON-
NECT MANAGE adjusts the brightness
of the luminaire such that the work area
is illuminated homogeneously.
Adjusting the detection range of the
PIR sensor
X Position the spherical sensor head in
the required direction.
ENG
41