Bosch HMI 1 270 020 900 Notice Originale page 15

OBJ_BUCH-1397-001.book Page 15 Monday, January 17, 2011 3:11 PM
"SPORT": Powerful assistance for
sportive riding off road as well as
for urban traffic
"SPEED": Maximum assistance,
supporting highest cadence for
sportive riding
To change the assistance mode, press the
"mode" button 4 until the desired mode is dis-
played in indicator e.
Adjusting the Assistance Level
In the set assistance mode, the assistance level
can be adjusted anytime, even during riding.
Note: For individual versions, it is possible that
the assistance level is pre-set and cannot be
changed.
A maximum of three assistance levels as well as
the assistance shut-off are possible.
Assistance
degree* at:
Assistance mode "1"
"ECO" 30 %
"TOUR" 50 %
"SPORT" 55 %
"SPEED" 60 %
* The assistance degree can vary for individual versions.
To increase the assistance level, press the
button 6 until the desired level is displayed in in-
dicator c.
To decrease the assistance level, press the
button 7 until the desired level is displayed in in-
dicator c.
In assistance level "0", the drive is switched off.
The eBike can be operated as a normal bicycle
through pedaling.
Bosch ebike Systems
Switching the Lighting On/Off
Depending on country-specific regulations, two
lighting versions are possible:
– The front light, rear light and display lighting
– Only the display lighting can be switched on
For both versions, the lighting is switched on by
pressing the "light" button 5. The lighting indi-
cator b appears on the display.
To switch off the lighting, press the "light" but-
ton 5 again; the lighting indicator b goes out.
Speed and Distance Indicators
Note: Depending on country-specific version,
distance and speed can either be displayed in
"km" and "km/h" or in "mi" and "mph". Adjust-
ment of the drive HMI and the selection of the
display possibilities for the km and mile version
Assistance level
are identical.
"2" "3"
The speed indication a always displays the cur-
60 % 90 %
rent speed.
100 % 160 % The following indications are available in multi-
function indicator d:
110 % 200 %
130 % 250 %
tery charge (for constant conditions such as
assistance mode, assistance level, route profile
etc.)
To switch within the multi-function indicator,
press the "info/reset" button 3 until the desired
function is displayed.
To reset the trip distance "trip" and the average
speed "avg", switch to one of both indications
and then press the "info/reset" button 3 until
the indication is reset to zero.
can be switched on and off at the same time
via the drive HMI.
and off; the front and rear light of the eBike
are independent of the drive HMI.
Total distance "odo": Indi-
cates the total distance cov-
ered with the eBike
Trip distance "trip": Dis-
tance covered since the last
reset
Average speed "avg": Aver-
age speed achieved since
the last reset
Range "range": Estimated
range of the available bat-
0 275 007 X00 | (17.1.11)
English | 15