Rinsing Cycle - Philips HD8030 Mode D'emploi

M A X
4203_000_7242_1_DFU Booklet_Lux_A5_v2.indd 25
8 Press the 1-cup button and the 2-cup button simultaneously for 1
second to start the descaling procedure.
, The activity light and the CALC CLEAN light both flash slowly to
indicate that the descaling cycle has started.
The water-descaling solution mixture comes out at intervals. The
,
coffeemaker stops descaling a few times to let the descaling solution
act.
When the water tank is empty, the descaling cycle is finished. The
,
activity light goes out, the CALC CLEAN light starts flashing quickly
and the 'water tank empty' light goes on.
Do not interrupt the descaling cycle.
Note: If you switch off the coffeemaker during the descaling cycle, the CALC
CLEAN light starts flashing quickly when you switch on the coffeemaker. In
that case, you have to complete the whole descaling procedure from the start.

rinsing cycle

1 Remove the water tank from the coffeemaker.
2 Rinse the water tank under the tap.
3 Fill the water tank with cold tap water up to the MAX indication and
slide the water tank back into the coffeemaker.
4 Empty the bowl (1) and place it back onto the drip tray cover (2).
EnglisH
25
5/29/12 5:50 PM