Maintenance Instructions - Paoli BLUE DEVIL Série Manuel D'utilisation Et D'entretien

MAINTENANCE INSTRUCTIONS

Before any maintenance, always make
sure that the air supply of the wheel gun
is depressurized (no air pressure), and
only after unplugging the wheel gun and
performing maintenance.
L Use only recommended lubricants.
L At regular intervals supply the wheel gun
with the addition of lubricant (special oil
for Paoli air impact wrench motors or very
fluid oil for air tools), in order to keep
the appliance efficient and to extend its
service life. Place a few drops of oil in
the air inlet of the wheel gun
Fig.2-A).
L Every week it is recommended to
lubricate (with special oil for Paoli air
impact wrench motors or very fluid oil for
air tools) the oil felt, by loosening (use a
1/4" Allen key) the oil plug in the bottom
side of the wheel gun; then tighten again
this oil plug (view figure
L Ship the wheel gun back to the PAOLI
facilities at least once per year for the
complete overhauling.
L Do not carry out maintenance with
improper tools, make use of the attached
exploded drawing with the list of spare
parts.
SCRAPPING
Separate the components on the basis of the nature of the materials of which they are made. The
components must be disposed of according to the laws in force.
ENGLISH
8
OPERATING AND MAINTENANCE MANUAL
L Indicate the parts most subject to wear,
L Use only genuine spare parts and
L Before
(view figure
Fig.2-H).
L If the wheel gun is left unused for long periods
to be dismantled and checked at regular
intervals, as well as a list of malfunctions,
if any, and the corrective action.
authorized service organizations.
every race
recommended to clean the motor by
introducing diesel oil (~10cc) through
the air inlet, while keeping the trigger
pressed; then running the wheel gun
clockwise and anticlockwise (please pay
attention to the exhaust coming out from
the top of the wheel gun during this
operation - view figure
the inside washing, repeat the previous
operation with special oil for Paoli air
impact wrench motors (~5cc) or very fluid
oil for air tools. These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
we recommend putting some oil (special oil
for Paoli air impact wrench motors) into the air
inlet (view figure Fig.2-A) and letting it run for a
few seconds before putting it away. In this way
the internal components will remain lubricated.
it is strongly
Fig.2-B). After