General Instructions - Paoli BLUE DEVIL Série Manuel D'utilisation Et D'entretien

OPERATING AND MAINTENANCE MANUAL

GENERAL INSTRUCTIONS

L Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L Do not operate the wheel gun without the
prescribed safety devices.
L The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L Verify that the WARNING label
Fig.1-W) is present and legible, otherwise
replace it by applying new one in the original
position.
OPERATING INSTRUCTIONS
L Always use a wheel gun with the tightening
torque corresponding to the one required by
the application.
L Please pay attention to your wheel gun
version:
⚪ the Fast Left Hand (LH) version loosens
nuts tightened clockwise faster;
⚪ the Fast Right Hand (RH) version loosens
nuts tightened anticlockwise faster;
⚪ 60/40 version allows you to have a ratio
of differentiation between fast side and
slow side of "60 : 40";
⚪ 70/30 version allows you to have a ratio
of differentiation between fast side and
slow side of "70 : 30".
L In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the rotation reverser grub
screw (view figure Fig.2-D).
Original operating instructions
Clutch Cover
Motor Cover
(view figure
- The original language of these instructions is English.
TAB. A
L Do not use the wheel gun with the screws of
the clutch cover (view figure
motor cover (view figure
tight enough (see table Tab. A "Tightening
Torques"). If not tighten them with a torque
wrench following the tightening sequence
shown (view figures Fig.2-F and
L Pay attention to the exhaust coming out
by the wheel gun during operation
figure Fig.2-B). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L The standard adjustment of the force necessary
for the translation of the rotation reverse shaft,
and thus the reverse is already performed
by Dino Paoli s.r.l.. A personalized set of this
force is possible, however, for specific needs
of the operator, acting uniformly on the nr.2
(two) rotation reverser grub screws
Fig.2-C). Tightening the grub screws you will
have an increase in the force required, loosening
them you will have its decrease. Ensure that the
individual regulation does not create problems
of accidental reversal of the direction of rotation.
Perform this adjustment always disconnected
the wheel gun from the air supply.
L The modes for the correct grip intended for
use of the wheel gun is as follows
Fig.2-E):
⚪ right hand grip on the gun body;
⚪ left hand grip on the surface of the clutch
cover.
TIGHTENING TORQUES
M5 Screw
M5 Screw
Fig.1-E) or the
Fig.1-P) loose or not
Fig.2-G).
(view
(view figure
(view figure
10 Nm
10 Nm
ENGLISH
5