After Operation - NSK PRESTO AQUA LUX Manuel Technique

Turbine sans lubrification avec spray
Masquer les pouces Voir aussi pour PRESTO AQUA LUX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4. Operational Procedures of Control Unit
( 1 ) Set the Drive Air Pressure
Connect to compressed air supply air and adjust to 0.3MPa by pulling the Chip Air Adjustment Knob upward and turn in the
desired direction. When adjusted correctly push the knob down to lock.
( 2 ) Set the Water Supply
Depending on the water supply you must set the Water
ON/OFF switch in the correct position by pulling outwards
or pushing inwards.
<Use of Water Supply Bottle>
Push the Water Mode Select Switch inwards until it stops.
( Fig.11 ) .
<Use of Tap Water>
Pull the Water Mode Select Switch outwards until it stops.
( Fig. 11 ) Open the main cock of the tap water.
CAUTION
Properly set the Water Mode Select Switch in the ON/OFF position. If the switch is not in the correct position air
may enter the system.
( 3 ) Operation
Depressing the Foot Control starts operation. If the Water ON/OFF switch is set to the ON side, water supply is also started.
( 4 ) Adjustment of the Amount of Water Supplied
Check the amount of water and adjust the volume with the Water Adjustment Knob.
CAUTION
supply; therefore adjustments may be necessary.
hose. This could result in a slow down the water flow when starting up the handpiece. In this case, turn the
water volume up fully to clear the line and reduce again as necessary.
( 5 ) Adjustment of Chip Air
Check the spray condition and adjust the amount of Chip Air with the Chip Air Adjustment Knob. Increasing the chip air
results in water turning from jet to spray and finally to fine mist. Decreasing the Chip Air has the reverse effect.
( 6 ) LED ON/OFF
LED switch is turned 'ON' it will illuminate once the Foot Control is depressed.
( 7 ) LED Light Adjustment Knob
Check the LED light condition and adjust the amount of light with the LED Light Adjustmen Knob.

(8) After Operation

After completion of operation always close the main air cock.
( when water supply is used )
7
Water Mode Select Switch
Water Mode Select Switch
Use of Water Supply Bottle
Use of Water Supply Bottle
Use of Tap Water
Use of Tap Water
( when water supply is used )
Fig. 11

Publicité

Table des Matières
loading

Table des Matières