Royal Sovereign RWD-1600B Guide D'utilisation page 7

PRODUCT OPERATION
1. Place the water dispenser on a level surface. Plug the water dispenser into a grounded power
outlet.
2. First, turn the Hot Water switch on the back of the unit into the ON position. Next, turn the
Cold Water switch into the ON position. DO NOT TURN ON BOTH SWITCHES AT THE SAME
TIME. Once this is completed both cooling and heating indicator lights should light up.
3. First, the unit will pump the water from the water bottle into the cooling and heating tanks, and
then the unit's compressor and heater will start to operate.
4. After both switches are turned on, it is recommended that you wait 30 minutes before usage.
After 30 minutes, the water dispenser will be ready to dispense hot, cold, and room
temperature water.
5. For ideal usage, it is recommended that 2 Liters of water runs through the water dispenser
before use. This is recommended as the unit has been sitting idle during manufacturing.
6. It is recommended that if the Hot Water option is not used, the Hot Water Switch (Red) be
turned OFF. This will help conserve energy.
NOTE: The appliance is designed to provide hot or cold water whenever you need it. It will
automatically turn on and off when hot and cold water reaches the desired temperatures.
7