General Information - Hilti WSC 70 Mode D'emploi

ORIGINAL OPERATING INSTRUCTIONS
WSC 70 / WSC 55 circular saw
It is essential that the operating instructions
en
are read before the power tool is operated for
the first time.
Always keep these operating instructions to-
gether with the power tool.
Ensure that the operating instructions are
with the power tool when it is given to other
persons.
Contents

1 General information

2 Description
3 Accessories
4 Technical data
5 Safety instructions
6 Operation
7 Care and maintenance
8 Troubleshooting
9 Disposal
10 Manufacturer's warranty - tools
11 EC declaration of conformity (original)
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.
1 General information
1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
14
In these operating instructions, the designation "the
power tool" always refers to the WSC 70 or WSC 55
circular saw.
Components, operating controls and indicators 1
On / off switch
@
Switch-on interlock
;
Auxiliary grip
=
Drive spindle lockbutton
%
Hexagon socket wrench
&
Cutting angle scale
(
Clamping lever for cutting angle adjustment
Page
)
Clamping screws for the parallel guide
14
+
Clamping lever for cutting depth adjustment
15
§
45°cutting line indicator
17
/
0°cutting line indicator
17
:
Parallel guide (rip fence)
18
·
Pivoting guard
21
$
Riving knife
24
£
Base plate
24
|
Guard
25
¡
25
Rotatable chip ejector
26 Q
Drive spindle
W
Mounting flange
E
Clamping flange
R
Clamping screw
T
Cutting depth scale
Z
Riving knife fastening screws
U
Pivoting guard operating lever
I
Chip deflector guard
O
Chip deflector guard release
P
Angle extender for 50° cuts
Ü
1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning:
electricity