DeWalt DW746 Guide D'utilisation page 6

d. Plastic and composition (like hardboard) materials maybe cut
on your saw. However, since these are usually quite hard and
slippery, the anti-kickback pawls may not stop a kickback.
Therefore, be especially attentive to following proper set up and
cutting procedures for ripping.
e. Use saw blade guard and splitter for every operation for which it
can be used, including all through-sawing.
f. Push the workpiece past the saw blade prior to release.
g. NEVER rip a workpiece that is twisted or warped, or does not have
a straight edge to guide along the fence.
h. Use featherboards when the anti-kickback device or the guard and
splitter cannot be used.
i. NEVER sawing a large workpiece that cannot be controlled.
j. NEVER use the fence as a guide or length stop when
crosscutting.
k. NEVER saw a workpiece with loose knots, flaws, nails or other
foreign objects.
l. NEVER rip a workpiece shorter than 10" (254 mm).
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
the State of California to cause cancer, birth defects or other reproduc-
tive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work
in a well-ventilated area and work with approved safety equipment,
such as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding, saw-
ing, grinding, drilling and other construction activities. Wear
protective clothing and wash exposed areas with soap and
water. Allowing dust to get into your mouth, eyes or lay on the skin
may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropri-
ate for the dust exposure. Direct particles away from face and body.
Always operate tool in well-ventilated area and provide for proper dust
removal. Use dust collection system wherever possible.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Hardware Included with the DW746 Woodworker's Table Saw
BOLT
10 MM X 35 MM
(2 PIECES)
FLAT HEAD SCREW
BOLT
10 MM X 25 MM
(8 PIECES)
CARRIAGE BOLT
8 MM X 20 MM
(4 PIECES)
FLAT WASHER
(14 PIECES)
10 MM LOCK WASHER
(14 PIECES)
4
T50 TORX
10 MM X 30 MM
(4 PIECES)
M 10 NUT
16 mm HEX
(8 PIECES)
M 8 NUT
13 MM HEX
(4 PIECES)
8 MM LOCK WASHER
(4 PIECES)
WRENCH
HOOK
(1)
PARTS SHOWN ARE
FULL SIZE - EXTRA
FASTENERS MAY HAVE
BEEN INCLUDED
5 mm
HEX
WRENCH
( 1 )
T50
TORX
WRENCH
(1)