Before Calling For Service - Thermador Professional Série Consignes De Sécurité

Before Calling for Service

Before calling Customer Service, consider the
suggestions and instructions below:
Problem
Neither the display nor the oven
operates.
The display works, but the oven
will not operate.
The power goes off before the
cook time has elapsed.
The microwave power level
switches from power level 100%
to power level 80%.
You see sparks or arcing.
The turntable makes noises or
sticks.
Using your microwave causes
TV or radio interference.
The touch buttons do not oper-
ate properly
The display shows error mes-
sage and Customer Service
number
The display shows "Tempera-
ture Sensor Error" and Cus-
tomer Service number
The display shows "Humidity
Sensor Error" and Customer
Service number
The display shows "Tempera-
ture Error" and Customer Ser-
vice number
Suggestion
Reset the household circuit breaker or replace any blown fuses.
▯
Have an authorized servicer check if the appliance is properly installed and
▯
grounded.
Make sure the oven door is closed securely and completely.
▯
Check to see if packing material or other materials are stuck to the door seal.
▯
Check for damage to the oven door.
▯
Check the oven is not in Demo Mode, it will operate but not heat.
▯
Reset the clock and any cooking instructions.
▯
Reset the household circuit breaker or replace any blown fuses.
▯
If the oven is set to cook for more than 30 minutes at 100% power level, it will
automatically reduce the power to a 80% power level after 30 minutes to avoid
overcooking.
Remove any metallic utensils, cookware or metal ties from the oven cavity. If using
aluminum foil, use only narrow strips and allow at least one inch between the foil
and the interior oven walls.
Clean the underside of the metal tray turntable, and the oven cavity bottom.
▯
Make sure the metal tray turntable is positioned correctly.
▯
This is similar to the interference caused by other small appliances, such as hair
dryers. Move your microwave further away from other appliances, like your TV or
radio.
This may be due to condensation on keypad.
Clean the control panel with a dry cloth. Disconnect the appliance from the power
supply by switching off the fuse in the fuse box and switch it back on after
10 seconds. If the problem persists, please shut off the appliance and have an
authorized servicer check if the appliance is properly grounded.
A malfunction has occurred. Note any error messages that may appear on the dis-
play. Disconnect the appliance from the power supply by switching off the fuse in
the fuse box and call an authorized servicer.
Touch the display and re-enter settings. If the error occurs again, call Customer
Service.
Touch the display and re-enter settings. If the error occurs again, call Customer
Service.
Touch the display and re-enter settings. If the error occurs again, call Customer
Service.
33