Electrical Connection - Airelec PARIS DIGITAL Manuel D'utilisation

a screwdriver by turning the locking tabs.
Place the bracket against the wall vertically posing the lower latches on the floor.
o
Mark, drill and dowel 2 holes in the upper holes of the bracket (A in picture 3 (1)).
o
Slide the bracket upwards to superimpose the drilled holes in the wall and the
o
bottom holes of the bracket (picture 3 (2)).
Mark, drill and dowel the upper holes, screw on the bracket.
o
The distances A, C
and D (pict. 4) vary
according
convector output (see
sheet below).
HORIZONTAL
The electrical installation must be fitted with an Omni polar circuit
breaker with a contact opening gap of at least 3 mm. The power
supply must be protected by residual circuit breaker of not more
than 30mA, especially when installed in a bathroom. The pilot
wire (black) must never be connected to the earth (yellow-
green wire).
The electrical connection requires no disassembly. The heater
should not be installed under a wall socket.
The heater is equipped with a 3-wire power cord. The power cord is to be connected to the wall
connection box (Picture cons).
Phase = Brown
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid danger.
Installation:
The electrical installation must comply with standards in the country of
installation.
Check the tight fit of the wires into the terminals of the wall outlet.
Note: The instructions for programming are sent by the side-cons
signals, measured from the neutral.
to the
OUTPUT
A (mm)
B (mm)
C (mm)
D (mm)

4. ELECTRICAL CONNECTION

Respect the polarity:
Neutral = Blue/Grey
500 W 1000 W 1500 W
140 mm 178 mm 320 mm
195 mm 195 mm 195 mm
130 mm 150 mm 160 mm
130 mm 150 mm 160 mm
=English Version=
2000 W
405 mm
195 mm
197 mm
197 mm
Pilot Wire = Black
12