Dometic WAECO PerfectView M7LS Instructions De Montage Et De Service page 34

_M7LS.book Seite 34 Freitag, 14. Oktober 2011 5:32 17
Mounting the monitor
7.4 Connecting the monitor to an electricity supply (fig. f, page 10)
The circuit diagram for the monitor can be found in fig. f, page 10.
No. Description
1 Monitor
2 13-pin DIN plug
3 Connection cable
4 13-pin DIN socket
5 12 V positive cable (red): Connection to the positive pole of the voltage
source
6 Earth cable (black): Connection to the negative pole of the voltage source
7 6-pin DIN socket
8 Cable (green): Control input for the connection to the reversing lights
9 6-pin mini DIN plug
10 System cable
11 6-pin mini DIN socket
12 6-pin mini DIN plug
13 Camera
Observe the following instructions when laying the connection cable:
Feed the connection cable through existing ducts or other openings where possible
e. g. ventilation grilles. If no appropriate ducts or openings are available you will need
to drill a hole of ∅ 18 mm. Check beforehand that there is sufficient space on the other
side for the drill head to come out (fig. 2, page 4).
Please observe the notes from the chapter "General information on the electrical con-
nections" on page 30.
➤ Lay the monitor cable on the dashboard.
➤ Insert the plug of the monitor cable (2) in the socket (4) of the connection cable (3).
NOTICE!
A
Make sure the polarity is correct when connecting to a voltage source.
34
PerfectView M7LS
EN