Hendi 970362 Mode D'emploi page 7

Important remark:
The 970362 packing machine is ONLY suitable for use with embossed (patterned) bags.
Bags which are completely smooth cannot be used with this machine.
Use bags with a maximum opening width of 320 mm.
The recommended thickness of the bags is 100 µm.
Hendi bags items 971017 and 971024 are especially suitable.
Operation of the packing machine
1. Connect the machine to a 230 V outlet with ground.
2. Switch the machine on using the main button located on the right side of the machine. A digit from 1 to
9 will be displayed indicating the set vacuum level (the lower the digit the weaker the vacuum).
3. Then the digit will disappear and one red line will appear next to the "MAN" label.
4. The machine is ready to operate in manual mode.
Manual mode
1. Put the food product into the bag.
2. Lift the lid of the packing machine.
3. Place the bag on the heating strip with the embossed side facing down. The bag should not go beyond
the limiting strip (the metal ridge).
4. Close the top lid of the machine.
5. Push the START/STOP button shortly at the same time pressing down the top lid of the machine where
it is marked PUSH. This increases the tightness of the lid.
6. The machine's pump is switched on, while the display shows the letter "A"
7. Observe the bag from which air is removed.
8. When the desired vacuum level has been reached, push the SET/SEAL button – the heating strip is acti-
vated while the display shows numbers (countdown of heating time).
9. When the manometer shows the minimum value, you can easily open the lid of the machine.
10. The pump operation time in this mode cannot be regulated.
11. When you push the START/STOP button during operation of the pump the bag will not be sealed and
the vacuum will be released.
Automatic mode
1. The display shows a highlighted red line at the bottom next to the "MAN" label – this marks the manual
cycle.
2. Push the SET/SEAL button shortly – the line starts flashing.
3. Using the START/STOP button, other lines are activated (the second and third line with AUT 1 and AUT
2 label respectively).
4. As long as the lines are flashing you can change the mode from manual to one of the two available
automatic modes.
5. After selecting the desired operation mode of the machine, a digit from 1-9 starts flashing. It indicates
the vacuum level.
6. The vacuum level may be increased using the START/STOP button or decreased using the SET/SEAL
button but only when the digit is flashing.
7. After setting the vacuum level the digit stops flashing automatically and disappears. The display shows
a highlighted line (lines) which indicates the operation mode.
8. In the automatic mode (AUT 1 and AUT 2) press START/STOP to start the packing machine.
9. After removing air from the bag the machine will activate the heating strip automatically and switch off
the pump.
10. When the manometer shows the minimum value, you can easily open the lid of the machine.
NL EN
7