Technical Data; Product Features; Intended Use - Leister DIODE S Notice D'utilisation

Technical Data

Voltage
Frequency
Power
Temperature
Air volume, min. (20°C) [l/min]
Weight (incl. 3 m cable
and 3 m air hose)
Dimensions L x Ø
Protection class

Product Features

1. Nozzle*, slide-on type 1.1 . Nozzle*, screw-on type 2. Screw 3. Heating element for slide-on nozzles* 3.1. Heat-
ing element for screw-on nozzles* 4. Cooled protection tube 5. Handle 6. Air hose 7. Mains connection 8. Poten-
tiometer for temperature adjustment 9. Digital display

Intended Use

When observing the safety instructions and using original Leister accessories, this hot air tool is suitable for all hot
air applications listed in these operating instructions.
Applications
Welding of thermoplastics as well as individual thermoplastic elastomer and elastomer bitumen in the form of
plates, pipes, and profiles, sealing layers, coated fabrics, foils, foams, tiles and layers. The following methods/
procedures are possible: Overlap, wire, band, heating element and fusion welding with Leister nozzles
Heating up for forming, bending and sleeve coupling of thermoplastic components and plastic granules
Drying of moist surfaces
Shrinking of heat-shrinkable tubing or sleeves, foils, foil strips, solder connectors and form components
Soldering of copper tubing, solder connectors and metal foils
Defrosting frozen water lines
Activating/dissolving solvent-free and hot-melt adhesives
Separating and melting of synthetic fiber and fabric
Removing of plastic flash (deflashing) and glossing of plastic surfaces
Mounting the Nozzle
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle, allow the unit to cool
down completely or use a suitable tool.
A falling down nozzle can set an object on fire. Nozzles must be mounted firmly and secure on the unit.
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original noz-
zles according to the table that are suitable for your unit.
For units with slide-on nozzle*:
Slide the nozzle 1 onto the heating-element tube 3 and tighten the screw 2.
For units with screw-on nozzle*:
Screw the nozzle 1.1 onto the heating-element tube 3.1 and tighten using an open-end spanner, size 17 mm.
* Nozzles not included in the delivery scope!
[V] 42
[Hz]
[W] 600
[°C]
[°F]
[cfm]
[kg]
[lbs]
[mm]
English - 9 -
DIODE S and DIODE PID
100
50/60
1400
20 – 600
70 – 1110
1.4
1.15
2.5
265 x Ø 40
II/ (Double insulated)
120
1600
40
230
1600