Canceling A Cycle; Adding Items During A Cycle - Haier HDBC100AFS Guide De L'utilisateur

CANCELING A CYCLE

Anytime during a cycle, press START/PAUSE.
Your dishwasher will start a 2-minute drain (if needed). Let the dishwasher
drain completely. The light turns off after 2 minutes.
NOTE: If your dishwasher does not need draining, press START/PAUSE again to turn
off the light. Select a new cycle.
To stop the drain:
Press START/PAUSE again to stop the drain immediately. Remember to drain the
dishwasher before starting a new cycle.
To clear the indicators:
Press START/PAUSE before starting the dishwasher to clear all options and cycles.
CHANGING A CYCLE
During the first fill of a cycle
1. Press a new cycle.
2. Check the detergent dispensers. They must be filled properly for the new cycle.
After the first fill of a cycle
1. Press START/PAUSE.
Your dishwasher will start a 2-minute drain (if needed). Let the dishwasher
drain completely. The light turns off after 2 minutes.
NOTE: If your dishwasher does not need draining, press START/PAUSE again to turn
the light off.
1. Check the detergent dispensers. They must be filled properly for the new cycle.
2. Press a new cycle.

ADDING ITEMS DURING A CYCLE

You can add an item anytime before the main wash starts. Open the door and check
the detergent dispenser. If the cover is still closed, you can add items.
To add items:
1. Open the door slightly. Wait for the spraying action to stop before opening the
door completely.
2. If the detergent dispenser cover is still closed, add the item.
3. Close the door firmly until it latches. The dishwasher resumes the cycle after
about a 10 second pause.
DELAY
Select Delay to run your dishwasher at a later time or during off-peak hours.
You can add items to the load anytime during the delay countdown. After
adding items, close the door firmly until it latches.
You can delay the start of a cycle up to 12 hours in 3 hour increments (3, 6, 9 or
12 Hr)
16