dji ZENMUSE X7 Guide De Démarrage Rapide page 7

Mount the camera lens with the lens mount facing downward to prevent dust from
entering the sensor, which may negatively affect its performance. DO NOT touch the
sensor unit if you find dust or impurities on it, and refer to the User Manual on how to
clean the sensor unit.
DO NOT press the lens release button while attaching the lens.
Mounting the Zenmuse X7 to an Aircraft
The following steps show how to mount the Zenmuse X7 to a DJI Inspire 2 drone:
1. Remove the gimbal cap from the Zenmuse X7.
2. Press the gimbal and camera detach button on the Inspire 2. Rotate the gimbal cap on the
Inspire 2 to remove it.
3. Align the white dot on the gimbal with the red dot on the Inspire 2 and insert the gimbal.
4. Rotate the gimbal lock to the locked position by aligning the red dots.
1 1
Always ensure that the Gimbal Connector 2.0 on the Inspire 2 is positioned correctly
when mounting, otherwise the camera will not mount.
Remove the Zenmuse X7 by pressing the gimbal and camera detach button on the
Inspire 2.
Only remove the Zenmuse X7 after powering off the aircraft.
Removing the Camera Lens
To remove the camera lens, hold down the lens release button and rotate the camera lens
counterclockwise to detach it.
DO NOT remove the balancing ring and the lens hood when
attaching the lens cap and rear cap to protect the lens.
Attach the camera body cap to the lens mount, the gimbal
cap to the gimbal connector, and the lens cap and rear cap
to the lens for protection after removing the camera lens.
2 3
4
A
B
5